SOFTWARE FOR BENTLEY

SOFTWARE FOR BENTLEY

$3,900.00

VELOS STAGE 2 PERFORMANCE SOFTWARE FOR BENTLEY SUPERSPORTS

$3,900.00

Manufacturers Velos Tuning

note – Tuning available for all Bentley’s. Please email info@velosdesigwnerks or call for more information. 

The Velos Stage 2 Performance Software (tune) for the Bentley Supersports is a complete remap of both ECU’s and increases your Bentley W12 output by over 20%. With peak gains of 193 lb ft of torque and 181 HP the Velos Performance upgrade for your Bentley is a must for the enthusiasts looking to maximize their Bentleys output without any compromise. The remap consist of adjustments to several maps including fuel, ignition, throttle, boost, and other vital area required for the vehicle to operate as intended from the manufacturer. Changes to limiters allow the W12 motor to operate at full potential while staying well within safety parameters.

The Bentley Supersports gained its fame from being the fastest Bentley Production car ever built. With a top speed limit of 210 MPH from factory our engineers focused on maximizing mid range power where the majority of time is spent. Through careful remapping they were able to increase the cars output by 193 lb ft of torque and 181 hp at 5000 RPM (as seen on our dyne chart below). Our performance software upgrade for the Bentley Supersports provides the consumer with impressive gains that can be expected anywhere in the World.

– Peak Gains of 193 tq & 181 hp @ 5000 rpm 

 

  • Increased Boost Levels
  • Improved Shifting
  • Peak gains at 5,000 rpm
  • Improved Throttle Response
  • Increased Gains in mid rpm range
  • Improved Gas Mileage
  • Refined a/f ratio
  • Refined drivability
  • Improved Part throttle response

 

16537980926_c6c7278881_z

16562877662_f3e45cda64_z

 

Dyno Charts:

STD

15891381894_9989d09c9f_b

SAE

 

16326485240_0c4e0eec37_b

Conditions:

16487945136_8a73e4da8e_b

Dyno video:

 

ECU Location:

Please disconnect negative on battery located inside trunk on driver side.

Both ECU’s are located on the passenger side (right) of the vehicle against the firewall inside the engine bay. Careful remove top cover (2 screws w/ half twist)

Carefully unclip connectors and slide out ECU’s. Contact our technical team at 7864016520 for assistance.

ECU (connectors) are labeled 01 & 02. Please label each ECU

IMG_2342

IMG_2343

IMG_2341

SKU: benttune Category:

Reviews

There are no reviews yet.

Be the first to review “SOFTWARE FOR BENTLEY”

Your email address will not be published. Required fields are marked *